assembling darts

assembling darts,take pre-cut backing material and lay two straightened wires as shown.See bill of materials for discription of wire,I used brass wire available at Wal-Mart crafts dept. or any other suitable wire of the same dimensions. Wires are straightened by taking about a yard of wire and anchoring one end on a wall hook or other suitable anchoring device ,then wrapping the other end around a screwdriver and applying a slow and steady pull.You will feel the wire stretch as it becomes perfectly straight.After stretching is done snip off both ends(take care not to bend it) and lay carefully on table for cutting to length.You will need two wires for each dart.
Posted by Hello
0 Comments:
Post a Comment
<< Home